pétrole Suivez nous Miles zhop cura esclave Humilité approfondir

Cura 4.2.0 Slicing Issue - Ultimaker Cura - Ultimaker Community of 3D Printing Experts

Weird lines on outer walls that does not appear on preview - Ultimaker Cura - Ultimaker Community of 3D Printing Experts

pla - How to remove unwanted filament trails from sharp corners - 3D Printing Stack Exchange

Z hop top layer during ironing process to increase quality of ironing. · Issue #11123 · Ultimaker/Cura · GitHub

Travel settings

Z-Hop only over printed parts" does not hop over supports · Issue #2401 · Ultimaker/Cura · GitHub

How to Use Z Hop in Cura – A Simple Guide – 3D Printerly

How to avoid those lines with ironing? I use Cura, one is monotonic and the other isnt : r/FixMyPrint

Smooth Two Color Inlay 3D Print Using Cura Z Hop on Creality Ender 3 - YouTube

Stringing with prusaslicer solved with Cura – How do I print this? (Printing help) – Prusa3D Forum

analyze retractions and Z hop - Ultimaker Cura - Ultimaker Community of 3D Printing Experts

Travel settings

From this, to this... All I did was disable z-hop in Cura : r/3Dprinting

Bad layer lines. Any solution? are the z screws bad? Stock cura setting, no zhop at 205 : r/anycubic

Z Hop at Retraction | ideaMaker Term Dictionary

4.2] Slicing fails because of zhop speed · Issue #6085 · Ultimaker/Cura · GitHub

Z-hop does not work when moving (cura 4.5) · Issue #7108 · Ultimaker/Cura · GitHub

Weird zhop type movement in vase mode (Cura 2.4) - Ultimaker Cura - Ultimaker Community of 3D Printing Experts

pla - How to remove unwanted filament trails from sharp corners - 3D Printing Stack Exchange